Cleaned it and tested it. It starts up and the hot air blower kicks on when at temp but does not seem to be blowing much air. It can see it spinning. When I adjust level up and down on the there is no increase decrease in noise/fan speed like their normally was. Also the thermostat button does not work now. It does not change it from thermostat to manual. It is stuck on manual. Is it a bad board? Which one? Any help greatly appreciated.
Vogelzang 5770
-
-
Hello
I would attach an AC test cord to the blower to see if it runs at full speed. If it does, then the blower isn't bad. If the blower tests good and you do not have the stove plugged into a good surge protector, then I would suspect the PC board is bad and you may order another one here.
https://www.eastcoasthearth.com/products/ap5660l-5660-circuit-board-for-new-lcd-control-panel-us-stove-5660-part-80631-80676?_pos=1&_sid=e0c7490a1&_ss=r -
-
Hello
This is the test cord for you.
It has all the clips so you can test anything. :-)
You must select 2 male & 2 Female clips from the drop down menu.
https://www.eastcoasthearth.com/products/pellet-stove-ac-line-test-cord-check-blowers-auger-motor-and-igniter-easily?_pos=1&_sid=52d99c2a5&_ss=rThis post was edited Oct 3, 2022 03:21PM -
-