My stove is not doing this... What's wrong? - Champ - Forums for Shopify

Forums
My stove is not doing this... What's wrong?

Latest Topics

pellets wont stop falling

i blew the fuse on the control panel and now the pellets fall all the time everything else works ...

2
Need help diagnosing a problem with my stove

1 2

I'm having issues with my stove and am trying to figure out where to begin.

21
St. Croix Pepin

My stove isn't feeding pellets! but does when I flip the manual feed switch. Could there be a bad...

2
Won’t run on medium or high heat

Have a Warnock Hersey bay view pellet stove . Seems to want to only run on low feed setting . Wh...

2
Serenity Castle ignites but auger stops

My stove starts up fine, but when it shifts from ignition mode to heat mode the auger stops feedi...

3
US Stove 5660 Blows 250 volt 8 amp fuse as soon as I hit the power button

Hi I have a US Stove 5660 pellet stove. Recently after cleaning it I started it and it shut off a...

6
Stove goes out

Stove quits with the 1 and 4 lights on

2
Harman P68 Not Getting Enough Pellets

I have a 5 year old P68. Just recently the auger is not supplying enough pellets to sustain the ...

6
Blinking 3&4 at start ‼️ won't work... Ahhh

Ashley pellet stove USC ap5660.. it will start when you hit the button and then within 15 seconds...

2
Some pellets are not falling into burn pot.

Why do some of the pellets fall out side the burn pot?

2
Magnum Countryside Unburned Pellets

I’ve had this stove for 7 years and had loved it. Now the pellets aren’t thoroughly burning and ...

4
Harmon XXV Distribution Fan

Hello. I replaced my exhaust fan because it kept shorting out the stove. I got the new one in pl...

2
The auger doesn't turn on my Harman pellet stove.

I have a Harman pellet stove. My auger doesn't turn.

12
Quadrafire Castille thermocouple issue

Hi folks - After replacing a thermocouple and an ignitor that were both visibly failed, I was not...

12
Quadra Fire Santa Fe.......control box lights

Control box blue light came on when the auger energized.....now only one steady red over the fuze...

20
USS Ashley mod AP5600L ser CH19186-36

Error code E3 and E4 is it the control board ? and is there an upgrade with a remote thermostat ?

10
Elledi fusion 8

No power, fuse and trip both ok, how to check if it is a faulty control board n100 or the display...

2
Kalor PAOLA 13D - Depress fault

Hi, Are there any experts familiar with the Kalor Paola 13D out there? My stove fails after 4-5...

3
Quadrafire cb 1200 smoke from exhaust outside

Have a 3 year old quad cb 1200 freestanding. Upon coming back from vacation the stove is constant...

4
Thelin Gnome Pellet Stove fan problem

I am having trouble with the fan in my Thelin Gnome pellet stove. The fan runs when the selector ...

8
Only 49 ac volts to auger motor.

Auger motor stopped during regular use, and will not come on at all any longer. Motor works fine...

2
Pelpro 130 Igniter wont turn off

I recently replaced my igniter, and noticed it wouldn't shut off once it ignited the pellets. It ...

1
Vulcan V-150 control panel issues

The fan is the only function that is working right now. It's been cleaned and all parts have been...

2
Breckwell SP600 Stir pot motor

Installed new stir pot motor, turned stove on and motor runs continuously- even before starting t...

2
ASHLEY 5500m pellet stove

How to reset controls...Pellets feeding hopper to fast...over flowing..

7
Mon poile ne démarre pas

Quand je l’allume il injecte des granule et apprêt ça l’arête et la lumière 3 et 4 ce mère a fla...

2
Santa Fe quadrafire insert

My insert is 18 years old and I have replaced blower snap discs and auger motor before to keep it...

5
Pleasant hearth pellet stove auger motor

Everything working fine then auger motor reverses wraps wires around and pulls plugs apart shutti...

2
Pleasant hearth pellet stove auger motor

Everything working fine then auger motor reverses wraps wires around and pulls plugs apart shutti...

1
England 25-puf completely dead

2006 model englander, was running fine and died suddenly. Replaced glass fuse and still won't pow...

3
Auger Not Turning

Evolution Pellet Stove Freestanding 25-EP 55-SHPEP 55-TRPEP Hi! The auger isn't turning, and I'm...

2
Stove goes into shut down

I have a Pelpro Bayview, it had a acutron 2 control board that recently went crazy, I’ve replaced...

2
Pellets smoldering after shut down

I have a king 5000 stove after shut down about 8 or 10 pellets fall into burn pot and smolder fil...

3
Timberwolf tpi35

1 2

When starting up my pellet stove it fires up fine and everything seems fine. After 20 minutes or ...

28
Pellets just keep running

I have a Quadrafire that I have had for a couple of years now and I have problem with the auger j...

2
St Croix hasting

my stove is not feeding pellets. i replaced convection fan cause it went. replaced augar motor an...

4
Intermittent Startup Enviro Mini

My 5 year old Enviro Mini shuts down soon after starting. The #4 idiot light (2nd from top), lig...

6
USSC 5660 goes out

Stove seems to start fine, after a while, the fire goes out and the 1-2 error code appears. Trie...

20
room blower fan

when the stove gets up to temp the blower fan comes on high speed and will not go to low speed my...

2
Hudson River Saranac won't start

My Hudson River Saranac pellet stove will not start up. If i push the start button the control pa...

5