Hi. I have an issue. Stove won't feed during run cycle. Light fire and once it comes up to temp, blower runs, but it won't feed. If you hit the auger button, it feeds nonstop. Vacuum switch is bypassed, other two switches meter out as functional. Stove ran fine until this started.
Magnum baby countryside not feeding corn
-
-
Hello
A bad vacuum switch or clogged vacuum hose, bad fire door or ash door seal will stop power to the auger.
Since this is bypassed it cannot be that
An open high limit switch mounted next to the exhaust blower will also stop power to the auger
If that tests as a closed circuit then it is good
The only thing else is a bad auger motor or
Something fell into the hopper jamming the auger
Remove all the pellets in the hopper and
Remove the auger motor from the the auger, if you can turn the auger by hand with no pellets in the hopper then it can be a weak or bad auger motor.
Here is a heavy duty auger motor that will work well in your stove.
This is for the BC-AC model
https://www.eastcoasthearth.com/products/2-rpm-heavy-duty-upgraded-auger-motor-for-magnum-baby-countryside-cw-from-rear-2-female-clips
If you have the
BC-DC Model
Here is the 12 VDV Auger Motor
https://www.eastcoasthearth.com/products/auger-motor-magnum-dc-2-rpm -
-
-
Hello
Yes The Control Panel can also be bad
Did you try the other suggestions first?
If they are ok then I would suspect the control panel.
https://www.eastcoasthearth.com/products/control-board-panel-magnum-baby-countryside-ac-rp2007