Kit to Update GMG P-1038 18 inch Auger for Daniel Boone Classic Grills from Cotter Pin Style to New T Pin Style- Auger & Auger Motor & Bushing- P-1113 P-1119 P1138

This Auger Kit will update your 110 VAC Daniel Boone Classic 18" cotter pin style auger with hole in the base of the shaft (P-1038) to the new 110 vac T-Pin style auger (P-1113). The new style T-Pin auger is easier to remove and replace compared to the old cotter pin style for cleaning and maintenance of your grill. This auger kit replaces the P-1038 cotter pin auger which is currently unavailable. This kit comes with a new auger motor and bushing, which are needed for the new T-Pin auger to fit

This kit contains the following 3 parts:

1. Short 18" Auger for Daniel Boone Classic Green Mountain Grill.  New T Pin Style P-1113

T-Pin Style Auger Motor- P-1119

3. Bushing Plate for T-Pin Style Auger P-1138

You can also buy these parts individually by clicking the link below.

Click here link to order the updated auger  for T-Pin Style

Click here link to order the updated auger motor for T-Pin Style auger

Click here link to order the updated auger bushing plate for T-Pin Style auger 

If you are not sure of which auger bit you require then please send us the following information.

Please check tag on back side lower right and put the following info into the Order Note in the shopping cart checkout page:

Manufacture Date

Serial and Model

Measure the length of your auger in your Pellet Grill.

Short Auger is 18"

Long Auger is 23"

Tell us which one it is.